Setup and Connections
E.H. Wachs
Part No. 69-SERVO-MAN-01, Rev. A
5
S
ETUP
AND
C
ONNECTIONS
Installing the Motor on the MDSF
1.
Mount and position the MDSF on the pipe according
to the instructions in the MDSF user’s manual.
You can remove the screws
from the pinion assembly to
mount the SDE. Engage the
square shaft in the pinion
gear, then rotate the drive so
you can install the screws.
2.
Mount the motor to the MDSF pinion assembly. Use a
lifting device if necessary; the drive motor assembly
has a lift handle.
• Insert the motor drive shaft all the way into the pin
-
ion spline, engaging the face gear.
• Snap the motor mounting clamp handle over the
motor adapter ring.
Figure 1-3. The photo shows the motor mounting
interface to the MDSF.
Installing the Motor on the EP 424
1.
Mount the EP 424 on the pipe according to the instruc
-
tions in the EP 424 user’s manual.
2.
Mount the optional adapter (81-180-00) onto the
motor shaft.
3.
Attach the motor to the drive mount on the EP 424.
NOTE
Drive shaft
Face gear
Adapter ring
