E-FLITE Mini Ultra Stick PNP, Инструкция по сборке

Страница: 18 / 28

 
3. Detach the servo arm from the servo. With the
radio on, center the servo first. Install the elevator
servo arm onto the servo and secure with servo
screw. Physically center the elevator so it is in line
with the stabilizer. Re-tighten the 2mm x 4mm
screw in the micro control connector to secure the
pushrod wire.
Note : We suggest you cut off some of the
excess pushrod wire using wire cutters so
that only approximately 1/4" (6mm) remains
beyond the control connector.

4. Repeat Steps 2 and 3 for the rudder
pushrod wire.
Final Assembly
Required Parts
• Fuselage w/motor and ESC
• Wing
• Battery
• Battery hatch
• 4-40 x 3/4" socket head bolt (2)
• #4 washer (2)
• Hook and loop tape
• Hook and loop strap
• EC3 battery connector
Required Tools and Adhesives
• Hex wrench: 3/32"
18