E-FLITE Mini Ultra Stick PNP, Инструкция по сборке

Страница: 14 / 28

Wing Preparation
Required Parts
• Fuselage
• Wing
• 6-channel receiver
• 4-40 x 3/4" socket head screw (2)
• 3mm washer (2)
Required Tools and Adhesives
• Screwdriver, #0 Phillips
Note
: For the optional Quad Flap modification,
please refer to information in the following
section.

1. Detach the servo arm from the servo by loosening
the servo screw. Temporarily plug the Y-harness
connecting the two servos into the receiver With
the radio on, center the servo. Re-install the
aileron servo arm onto the servo and secure with
the servo screw. Loosen the control connector
screw. Physically center the aileron so it lines
up with the wing. Re-tighten the 2mm x 4mm
screw in the micro control connector to secure the
aileron wire.

2. Repeat Step 1 for the remaining aileron linkage
installation.
14