RADIOWIDE FEATURES
24
4.12.2 RADIO WIDE SCAN LIST
General
With radio wide scanning, there is only one scan
list available regardless of the type of channel selected.
This list is user programmable in later models*, and it
can include up to 16 channels of any type. For
example, it could include six conventional channels
and ten SMARTNET/SmartZone channels. More
information on selecting and editing radio wide scan
lists follows.
Determining Channels in Radio Wide Scan List
The channels in early model radio wide scan lists
are indicated by selecting the radio wide scan mode.
With later models*, they can be determined only by
selecting the scan list edit mode (see “Editing Radio
Wide Scan List” which follows).
When the displayed channel is in the scan list
(scanned normally), the symbol is displayed next to
the zone number as shown in the following
illustration.
Editing a Radio Wide Scan List*
If the
RWS ED
option switch is programmed, the
radio wide scan list can be edited. Changes are perma-
nent (cycling power does not reselect a default condi-
tion). Proceed as follows:
1. Make sure that both standard and radio wide scan-
ning are off (the rotating icon is not indicated in
the right status display). Select the scan edit mode
by pressing the
RWS ED
option switch. This mode
is indicated by a triangle in the upper left corner of
the display (see Figure 2-3 on page 12.).
2. Select the channel you want to add or delete by
rotating the Select switch. After the last channel in
the current zone is displayed, the first valid channel
in the next zone is displayed and vice versa. Lists are
limited to 16 channels. If an attempt is made to add
more than 16, “LIST FULL” is displayed and a
channel must be deleted before another can be
added.
3. If the selected channel is in the scan list (scanned),
the symbol is displayed next to the zone number
as just described. To change the scan list status of
the displayed channel, press the Select switch.
4. To exit this mode and save the changes, press the
RWS ED
option switch again.
Scan List Indicator
Chnl
No.
*
This feature requires firmware 1.24.1/2.2.1/3.2.1 or
later and PCConfigure 1.22.0 or later.
