5
User Manual EE872 Modular Probe for CO
2
, RH, T and p
1.2.1 Mounting and Start-up
The device has been produced under state of the art manufacturing conditions, has been thoroughly
tested and has left the factory fulfilling all safety criteria. The manufacturer has taken all precautions to
ensure safe operation of the device. The user must ensure that the device is set up and installed in a
manner that does not have a negative effect on its safe use.
The user is responsible for observing all applicable safety guidelines, local and international, with
respect to safe installation and operation on the device. This user manual contains information and
warnings that must be observed by the user in order to ensure safe operation.
• Mounting, start-up, operation and maintenance of the device may be performed by qualified staff only.
Such staff must be authorized by the plant operator to carry out the mentioned activities.
• The qualified staff must have read and understood this user manual and must follow the instructions
contained within.
• All process and electrical connections shall be thoroughly checked by authorized staff before putting
the system into operation.
• Do not install or start-up a device supposed to be faulty. Make sure that such devices are not
accidentally used by marking them clearly as faulty.
• A faulty device may only be investigated and possibly repaired by qualified, trained and authorized
staff. If the fault cannot be fixed, the device shall be removed from the system.
• Service operations other than described in this user manual may only be performed
by the manufacturer.
2 Scope of Supply
• EE872 according ordering guide
• Test report according to DIN EN10204-2.2
• Quick User Guide
2.1 Accessories
• E+E Product Configuration Software
) EE-PCS
• Modbus configuration adapter
HA011018
• Connection cable M12 - flying leads
1.5 m (59.06”) / 5 m (196.85”) / 10 m (393.70”)
HA010819/20/21
• T-coupler M12 - M12
HA030204
• M12 cable connector for self assembly
HA010708
• Protection cap / calibration adapter
HA010785
• Protection cap for the M12 cable socket
HA010781
• Protection cap for the M12 plug of EE872
HA010782
• Mounting flange
HA010226
• Wall mounting clip Ø 25 mm
HA010227
• Radiation shield
HA010510
• M12x1 flanged coupling with 50 mm (1.97”) stranded wire HA010705
2.2 Spare Parts
• PTFE filter cap
HA010123
• Catalytic filter cap for H
2
O
2
sterilization
HA010124
• Replacement sensing module
EE872S-...
EE872S-
Model
CO
2
(default: heated)
M10
CO
2
+ p (default: heated)
M15
CO
2
+ T + RH + p (default: not heated)
M13
CO
2
range
1)
0...
2
000 ppm
HV1
0...
5
000 ppm
HV2
0...1 % (10 000 ppm)
HV3
0...3 % (30 000 ppm)
HV5
0...5 % (50 000 ppm)
HV6
1) The CO
2
range of the EE872S must be the same as of the original EE872 probe.
