7
User Manual EE850 Duct Sensor
3.3 Electrical Connection
3.4 Setup and Adjustment
The EE850 is ready to use and does not require any configuration by the user. The factory setup of
EE850 corresponds to the type number ordered. For ordering guide please see data sheet at
www.epluse.com/EE850.
If needed, the user can change the factory setup by using the optional USB Configuration Adapter
(HA011066) and the Product Configuration Software (EE-PCS). One can change the CO
2
output signal,
the scaling of the outputs and perform CO
2
, RH and T adjustment/calibration.
Please note:
The EE850 may not be connected to any additional power supply when using the USB
Configuration Adapter (HA011066).
GND*
GND*
GND
A
B
RS485
GND*
GND*
EE850-M11 / voltage output
EE850-M1xJ3 / digital output
EE850-M10 / current output
*
Very important:
For failure-free operation and performance according to the specs the supply GND and the
measurement GND must be wired separately.
GND*
GND*
RH
GND*
GND*
EE850-M10 / voltage output
EE850-M12 / voltage output
EE850-M10 and EE850-M11
EE850-M12
EE850-M1xJ3
PC
EE850
HA011066
