5
User Manual EE160 Humidity and Temperature Sensor for HVAC Applications
The steps recommended by the manufacturer for installation, inspections and maintenance work must
be observed and carried out for the safety of the user and for the functionality of the equipment.
Unauthorized product modification leads to loss of all warranty claims. This may be accomplished only
with an explicit permission of E+E Elektronik
®
!
1.2.3 Mounting, Start-up and Operation
The EE160 humidity and temperature sensor has been produced under state of the art manufacturing
conditions, has been thoroughly tested and has left the factory after fulfilling all safety criteria. The
manufacturer has taken all precautions to ensure safe operation of the device. The user must ensure
that the device is set up and installed in a manner that does not have a negative effect on its safe
use. The user is responsible for observing all applicable safety guidelines, local and international, with
respect to safe installation and operation on the device. This user manual contains information and
warnings that must be observed by the user in order to ensure safe operation.
Mounting, start-up, operation and maintenance of the device may be performed by qualified staff
only. Such staff must be authorized by the operator of the facility to carry out the mentioned activities.
The qualified staff must have read and understood this user manual and must follow the instructions
contained within.
All process and electrical connections shall be thoroughly checked by authorized staff before putting
the device into operation.
Do not install or start-up a device supposed to be faulty. Make sure that such devices are not
accidentally used by marking them clearly as faulty.
A faulty device may only be investigated and possibly repaired by qualified, trained and authorized
staff. If the fault cannot be fixed, the device shall be removed from the process.
Service operations other than described in this user manual may only be performed by the
manufacturer.
1.3 Environmental Aspects
Products from E+E Elektronik® are developed and manufactured in compliance with all relevant
environmental protection requirements. Please observe local regulations for the device disposal.
For disposal, the individual components of the device must be separated according to local recycling
regulations. The electronics shall be disposed of correctly as electronics waste.
2 Scope of Supply
Model
EE160 Wall mount
(Type T1)
EE160 Duct mount
(Type T2)
Additionally for all EE160
with RS485 interface
EE160 Humidity and Temperature Sensor
according to order code
Cable gland
Mounting kit
Mounting flange
Inspection certificate according to
DIN EN 10204-3.1
Quick Guide - EE160 RS485 Setup
3 Product Description