11
12
1000 Series E-Fence
1000 Series E-Fence
Customizing Collar Receiver
Replacing the Contact Points
The default setting is tone on and low stimulation mode. Each collar receiver can be
programmed to offer a warning tone, small, medium, & large dog stimulation profiles, with
10 levels of stimulation within the selected dog size stimulation profile.
Before you put the collar on your dog, the collar should be programmed. Each collar can
be programmed differently by the combination of warning tone, stimulation level and dog
size selection.
How to customize the Collar Receiver.
①
Change the value of warning tone, stimulation level, and dog size on the controller.
②
Place the collars on the top of the controller.
③
Press the “SET” button until the LED on the collar flashes from red to green.
④
If the LED keeps blinking green, it means collar setting is finished.
The standard 5/8” contact points are used for most dogs.
Thicker fur breeds require the longer 3/4” contact points.
Replace the 5/8” contact points by following the instructions below using the enclosed
contact point tool.
A. Loosen both contact points by rotating the contact point counter-clockwise using the
contact point tool.
B. Install the 3/4” contact points onto the bolt and tighten the contact points by rotating
them clockwise with the contact point tool.
* For dogs with either very short or very long or thick coats, please contact customer
service for an appropriate size set of contact points.
