15
DX-DTVMFP23
www.dynexproducts.com
STEP 6 - Option 1: Install on a wood stud wall
You’ll need
1
Locate the studs. Verify the centers of the studs with an edge-to-edge stud finder.
2
Align the wall plate (
A
) at the height you determined in the previous step, make
sure that it is level, then use a pencil to mark the lag bolt hole locations (4) on the
stud centers. Remove the wall plate (
A
).
3
Drill pilot holes to a depth of 2 in. (50 mm) using a 3/16 in. (5 mm) diameter drill bit.
Note:
Any drywall covering the wall must not exceed 5/8 in. (16 mm).
Edge-to edge stud
finder
P
(4)
Pencil
Drill
3/16" wood drill bit
1/2" socket wrench
Level
O
(4)
Wall plate (
A
)
Wood
stud
2 in. (50 mm)
3/16 in.
(5 mm)
- Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 11/2 x 31/2 in. (38 x 89 mm).
- Minimum spacing between horizontal fasteners cannot be less than 16 in. (40 cm)
