Dynaudio 9S, Руководство пользователя

Страница: 9 / 25

3. Power (Mode)
On: subwoofer is permanently on
Auto: subwoofer switches on when an input signal is detected
4. Gain
Subwoofer volume level.
5. Phase
Phase setting: phase can be set to 0° or 180°.
6. Low-pass
Subwoofer low-pass frequency: continuously variable from 50 to 150Hz.
7. SAT/SUB (output)
Output for connection of satellite speakers. This signal is processed according to the high-pass filter setting.
8. High-pass
Applies a high-pass filter to the signal routed to the T/SUB output:
Flat: signal is not processed
60: filter frequency at 60Hz
80: filter frequency at 80Hz
9. SAT/SUB (input)
Input for full bandwidth signal. The signal will be processed according to the high-pass filter setting and routed to
the SAT output.
10. LFE
LFE
LFE/Slave: input for LFE signal
Slave: output to (second) slave subwoofer if present
11. Mode
Subwoofer operation mode LFE or Slave:
LFE: select for normal or master use
Slave: select for slave use
Terminal pinout (sockets 9, 10 and 11)
▪
1 = 0
▪
2 = +
▪
3 = –
Damage due to improper connections!
CAUTION
Improper connections may damage the device.
Set the mains power switch to OFF before connecting the 9S.
Only switch on the subwoofer (mains power switch to ON) after all connections and configuration steps have
Before you start 9