Dynapac DRP45DX, Руководство по эксплуатации

Страница: 104 / 124

8.11.4 Checking the oil level in the exciter housing
NOTICE!
Components may get damaged!
– Use only oil of the permitted specification
Ä
Chapter 8.4 ‘List of fuels and lubricants’
on page 76 .
– Do not use low-ash engine oils for the exciter
shaft housing.
Protective equipment: n Working clothes
n Safety shoes
n Protective gloves
1. Drive the machine onto horizontal, level, firm ground.
2. Park the machine safely Ä Chapter 6.4 ‘Parking the machine
in secured condition’ on page 63 .
3. Allow the machine to cool down.
4. Clean the area around the bleeding screw (1) and filling/drain
plug (2).
5. Unscrew the bleeding screw.
6. Unscrew the filling/drain plug and check the oil level; top up if
necessary.
ð
Nominal value: Bottom edge of filling/drain bore.
7. Clean the bleed screw and filling/drain plug and screw them
in with a low-strength sealing agent (e.g. spare parts number:
DL 009 700 16).
8.11.5 Measures prior to extended shut-down period
8.11.5.1 Measures before shutting down
If the machine is shut down for a longer period of time, e.g. winter
season, the following work must be carried out:
1. Clean the machine thoroughly.
2. After shutting down store the machine under cover in a dry
and well ventilated room.
3. Spray a thin oil film onto to all lever joints and bearing points
without lubrication.
4. Repair damaged paint; preserve bare areas thoroughly with
anti-corrosive agent.
5. Clean the water separator.
6. Fill the fuel tank with diesel fuel to prevent the formation of
condensation water in the tank.
7. Change engine oil and oil filter.
1
2
B-695-0184
Fig. 134
Maintenance – As required
DRP45DX 104