Dynapac CC 82, Руководство по обслуживанию

Страница: 23 / 27

21 CC82/92 M092EN3
Switch off the engine, break the electric
power supply and press the parking brake/
emergency stop knob.
Loosen the plug (1) slightly, when it is at the position for
level check (2), so that it can later be unscrewed by
hand.
Position the roller on a level surface and slowly drive it
until the plug (1) is at the bottom position.
Place a receptacle that will hold at least 5 liters
under the plug. Save the oil and dispose of it in
an approved manner.
Remove the drain plug and drain off the fluid.
See Every 250 hours of operation with regard to filling.
Place the roller on a level surface. Switch
the engine off and push in the reserve/
parking brake knob for all checking and
adjustments on the roller, unless otherwise
specified.
Danger of being burned when draining hot
oil. Protect your hands.
Place a receptacle that will hold at least 50
liters under the plug. Save the oil and dispose
of it in an approved manner.
Remove the drain plug (1) and allow all the oil to run
out, wipe and refit the drain plug.
Fill with fresh hydraulic fluid of the grade
indicated in the Lubricant specification.
Replace the hydraulic filter as described under the
heading ”Every 1000 hours of operation.”
Start the engine and operate the various hydraulic
functions. Check the level in the reservoir and top off
as required.
Make sure that ventilation (extraction) is
adequate if the engine is run indoors. Risk
of carbon monoxide poisoning.
Hydraulic reservoir
– Changing the fluid
1
Drum – Changing the oil
1
2
2
Fig. 31 Left side of roller
1. Drain plug
2. Exhaust pipe
Fig. 32 Drum, vibration side
1. Filler plug
2. Position for level check
EVERY 2000 HOURS OF OPERATION (Yearly)
WARNING
WARNING
WARNING
WARNING
CAUTION
CAUTION