Dynamite Vision Peak 2, Инструкция по эксплуатации

Страница: 1 / 3

Thank you for purchasing the Dynamite ®
Vision Peak 2 AC/DC Peak Detection
charger. This unique charger allows you to
visually monitor the charge cycle through-
out the charge process. The Vision Peak 2
automatically stops fast charging when the
battery pack is fully charged, protecting
the batteries from damage due to over-
charging. Immediately after the battery
pack has peaked, the charger automatically
transitions to trickle charge. This feature
will allow the battery pack to stay fully
charged until you are ready to use it.
By properly following these instructions,
this charger can provide you with many
years of trouble-free operation.
• Selectable 1-, 2- and 4-amp charge rates
• Charges 4- to 7-cell Ni-Cd and Ni-MH
battery packs
• 110V AC or 12V DC
• LED charge level indicators
• Peak detection circuitry
• Auto-trickle charge
• Heavy-duty 12V DC input alligator clips
• Tamiya-style output (battery) connector
• Voltmeter jacks
• Limited 5-year warranty
• Reciever pack charge lead adapter
This charger can be powered by connecting
it to a 12V DC power source, such as a
12V sealed battery (HAN102) or an auto-
mobile battery. If you choose to power the
charger by connecting it to your automobile
battery, the car must not be running!
To power the Vision Peak ™ 2 with AC
power, connect the AC power cord into
a standard 110V wall outlet.
Attach the red (positive) alligator clip
to the red (positive) terminal on your 12V
DC power source. Next, attach the black
(negative) alligator clip to the black (nega-
tive) terminal.
Caution: Do not use both power
sources simultaneously or damage
will occur.
1. Connect the charger to an input power
source as described previously.
2. Use the included Tamiya to receiver
adapter to connect the battery to
the charger.
3. Select the number of cells in the pack
you are going to charge.
Note: If the number of cells selected
does not match up with the actual
cells in the pack or has a damaged
cell, the charger will stop charging,
and the LEDs will blink.
4. Select the charge rate by pushing the
Start/Select button until the LED
indicates the correct charge rate. Once
the LED is solid, the charger is charging.
Note: When charging packs under
1000mAh, make certain that you
select the 1-amp charge rate. Receiver
packs that have a capacity of 1000mAh
or higher can be charged at 2 amps.
5. Watch the LED continue to climb until
all lights flash, indicating the battery is
fully charged. Once all of the LEDs are
lit and flashing, the charger automatically
transitions to trickle charge.
1. Connect the charger to an input power
source as described previously.
2. Connect the battery to the charger.
3. Select the number of cells in the pack
you are going to charge.
Note: If the number of cells that has
been selected does not match up with
the actual cells in the pack or has a
damaged cell, the charger will stop
charging, and the LEDs will blink.
4. Select the charge rate by pushing the
Start/Select button until the LED
indicates the correct charge rate. Once
the LED is solid, the charger is charging.
5. Watch the LED continue to climb until
all lights flash, indicating the battery is
fully charged.
INSTRUCTION MANUAL
Vision Peak 2 Features
AC Power
DC Power
Charging 4- to 5-Cell Receiver Packs
Supplying Power to the Charger
Charging 6- or 7-Cell Sub C Ni-Cd or
Ni-MH Battery Packs
VISION PEAK 2 ™
AC/DC Peak Detection Charger