Dynamic DYN-120 Скачать руководство пользователя страница 1

 

 

 

    

2” and 2” Tandem 

     Polarized-Media  

  Air Cleaners 

 

Installation  

Operation 

Manual 

All Dynamic Air Cleaners operate with the same basic principles of active-field polarized media.  

In the 2” Panel 

Air Cleaner, the 24 VAC input to the Powerhead is stepped up to 7 kV (DC) at very low current.  This voltage is 
applied to the center screen inside the replaceable media pad.  This creates an electrostatic field between the 
center screen and the grounded exterior metal screens.  The electrostatic field polarizes both the fibers in the 
media and airborne contaminants.  These are then attracted to and collected by the media fibers.  When the 
pads are loaded, they are easily removed and replaced. 
 
Dynamic 2” Air Cleaners typically slide into the standard 2” racks in the air handler.  They are available as 
individual Panels or as Tandem Panels.  Typically, a Panel Air Cleaner is used when there is only one filter per 
row.  Each Panel is wired separately. Tandem Panels are used when there are multiple Air Cleaners per row.  
They are connected mechanically and electrically to the adjacent Air Cleaner, and there is one electrical 
connection per row.  The entire row may be pulled out for service. Neoprene foam strips are used on the mating 
faces of the Air Cleaners in a row to block the flow of air between Panels.

 

Section I.  Sizing 

  
While Air Cleaner height is consistent with filter rack height, Air Cleaner widths are typically sized to minimize the 
number of Air Cleaners in a row and fill the width of the rack in the unit.  Keeping the Air Cleaner width consistent 
will also standardize replacement media pad size.  For example, a rack that has three 24”x24”x2” passive filters 
would typically take 

two 36”x24”x2” Dynamic Tandem Panels.  Make sure that there is enough room to slide out 

the larger Panel.  In the above example, the Powerhead would go on top on the long side.  When ordering, the 
first dimension is the side with the Powe

rhead.  Therefore, a 36”x24” Tandem is not the same as a 24”x36” 

Tandem.  Assuming a set of two, the first would give you an assembly that is 72” wide and 24” high and the 
second would yield an assembly that is 

48” wide and 36” high.   

 
Like passive filters, 2” Panels are undersized from the nominal dimensions.  They are undersized ½” on height 
(the height of the filter track) and ¼” on width.  Whenever possible, and on all retrofit applications, measure the 
filter racks rather than relying on the nominal dimensions of the passive filters.  

 

Section II.  Installation 

 

Dynamic 2” Panels slide into the existing filter racks.  The required 24 VAC may come from an on-board source, 
a dedicated transformer, or a Dynamic Control Panel, with optional pressure transmitter gauge.  Make certain 
that there is sufficient capacity (3 VA) when using an on-board transformer.  Follow all applicable local codes.  
Make certain the air handler is off when installing the Panels.   
 
In the case of a Panel Air Cleaner, each Panel will require an electrical connection.  With Tandem Panels, each 
row requires its own input. 

Отзывы: