Dynamic DX2-ACU, Руководство по установке, Страница: 36 / 56

GBK65701 DX2 Compact Remote Modules
Installation Manual Issue 1
See also :
6.4.1 User profile options
The system that has control is determined by the configuration mode setting and the mode button:
1. on powering up , the remote module that is initially in charge of the system is determined by
the configuration mode setting;
2. after powering up , a long press on the mode button changes which controller is in charge.
See also :
7.2.4 Mode button
7.2.10 Configuration mode
7.2.8 Sleep mode
Figure 33: Sleep mode
When the system enters into sleep mode, and if the DX2-ACU is the active
remote before entering sleep mode, all indicators on the DX2-ACU are
switched off except the battery gauge indicator. If the DX2-ACU is not the
active remote before entering sleep mode, all indicators on the DX2-ACU are
switched off, including the battery gauge indicator.
Waking a system from sleep depends on whether the remote module waking the system was the
active remote module before the system went to sleep.
7.2.8.1 Waking from sleep mode with active remote module
If the remote module waking the system was the active remote module before the system went to
sleep, then the system can be woken by either:
l
momentarily deflecting the joystick, or
l
pressing the power button.
Note
:
Set the joystick wake up parameter in Wizard to enable this functionality. The parameter name varies depending
on the master remote. For example, for a DX2-REM55x, set
Joystick Wake-up from Sleep parameter to Yes . Or, for
a DX-REMG91S, set the Enable Joystick Wakeup parameter to Yes .
7.2.8.2 Waking from sleep mode with inactive remote module
If the remote module waking the system was NOT the active remote module before the system went
to sleep, then the system can be woken ONLY by pressing the power button.
7.2.9 Lock mode
When a DX/DX2 system is locked, the DX2-ACU inputs and display are deactivated. A DX/DX2 system
cannot be locked or unlocked with the DX2-ACU, but the locked status can be displayed to the
attendant when the attendant presses the power button. The indication is different for DX and DX2
systems.
7.2.9.1 Locked indication in DX systems
To indicate a locked DX system, the mode button will flash (½ second on, ½ second off) when the
power button is pressed.
7.2.9.2 Locked indication in DX2 systems
To indicate a locked DX2 system, the mode button displays inhibit when the power button is pressed.
Page 34 - Operation