53DS---900--- --- ---117 (115 v)
53DS---900--- --- ---118 (230 v)
Installation Instructions
Accessory Condensate Pump
for Ductless Split System
Cooling Only and Heat Pump High Wall Units
(Size 009---036)
NOTE
: Read and become familiar with these instructions before
beginning installation.
SAFETY CONSIDERATIONS
Improper
installation,
adjustment,
alteration,
service,
maintenance, or use can cause explosion, fire, electrical shock, or
other conditions which may cause death, personal injury, or
property damage. Consult a qualified installer, service agency, or
your distributor or branch for information or assistance. The
qualified installer or agency must use factory--authorized kits or
accessories when modifying this product. Refer to the individual
instructions packaged with the kits or accessories when installing.
Follow all safety codes. Wear safety glasses, protective clothing,
and work gloves. Use quenching cloth for brazing operations.
Have fire extinguisher available. Read these instructions
thoroughly and follow all warnings or cautions included in
literature and attached to the unit. Consult local building codes
and current editions of the National Electrical Code (NEC) NFPA
70. In Canada, refer to current editions of the Canadian electrical
code CSA 22.1.
Recognize safety information. This is the safety--alert symbol
!
!
When you see this symbol on the unit and in instructions or
manuals, be alert to the potential for personal injury. Understand
these signal words; DANGER, WARNING, and CAUTION.
These words are used with the safety--alert symbol. DANGER
identifies the most serious hazards which
will
result in severe
personal injury or death. WARNING signifies hazards which
could
result in personal injury or death. CAUTION is used to
identify unsafe practices which
would
result in minor personal
injury or product and property damage. NOTE is used to
highlight suggestions which
will
result in enhanced installation,
reliability, or operation.
UNIT OPERATION HAZARD
Failure to follow this caution may result in unit failure
and/or damage.
Always follow instructions properly.
CAUTION
!
16’ Transparent
Suction Discharge Tubing
Condensate Pump
Assembly
Low Voltage
Power Cord
Transparent
Detection
Unit Vent Tubing
Detection Unit
Rubber
Adapter
Detection Unit
Mounting Bracket
Wire Ties (6)
Mounting Bracket
Power Cable
Adhesive
022 - 7/8”
022 - 7/8”
015 - 5/8”
015 - 5/8”
A12227
Fig. 1
---
Accessory Condensate Pump Kit
Table 1—Accessory Condensate Pump Kit Contents
ITEM
QTY
16---ft Transparent Suction/Discharge Tubing
1
Condensate Pump Assembly
1
Low---Voltage Power Cord
1
Transparent Detection Unit Vent Tubing
1
Power Cable
1
Wire Ties
6
Wall Mount Bracket
1
Adhesive
1
Detection Unit Mounting Bracket
1
Rubber Adapter
1
Detection Unit
1
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal injury
or death.
Before beginning any modification or installation of this kit,
be sure the main electrical disconnect is in the OFF position.
Ensure power is disconnected to the fan coil unit. On some
systems both the fan coil and the outdoor unit may be on the
same disconnect. Tag the disconnect switch with a suitable
warning label. There may be more than one disconnect.
!
WARNING