Dynamic Displays, Inc. User Manual Doc: 0048070
1625 Westgate Road 17C3 A/D Series Rev 2
Eau Claire, WI 54073 Glee 17C3 Page #6 of 26
•
Connect HDMI (High-Definition Multimedia Interface) Cable (Optional): If you have a DVI digital graphics card
adapter and a DVI cable, connect it to the DVI (IN) connector of the monitor. The optional DVI graphics
adapter and the DVI cable can be ordered by contacting Dynamic Displays.
•
Connect Audio signal Cable (Optional): Connect Audio In connector of the LCD monitor and an Audio Out
device (PC. DVD, CD) with the attached stereo mini cable.
•
Connect Touch Screen Cable (Optional): Connect the optional USB or RS 232 serial touch screen connection
to the driver card or system driving the touch screen controller.
•
Turn ON your monitor and system. If your monitor displays an image, installation is complete. If it does not
display an image, please refer Troubleshooting.
If your computer was off, turn on your computer/system. Your display should now operate as a normal computer
display showing your windows or whatever video is being sent to the flat panel.
Note: If for any reason the display
has a “Blue Screen”
with a message
“
O
ut of Range” or “No Input Signal”, your
system source is putting out a signal that is out of range or non compatible with the LCD’s video A/D board. If
this happens, make sure you are inputting the correct signal. If the display doesn’t work properly, it
may be
because:
•
The resolution is too high or low for the LCD.
•
The power source is incorrect.
MONITOR SETUP
Unlike CRT displays, the LCD panel has a fixed pixel format over a set area. So for best performance, the “native
resolution” setting is always
recommended. Use the following notes as a reference to setup your display.
•
8.4”, 10.4” and 12.1” monitors
: The native resolution of the LCD panel is 800 X 600; Recommended
resolution is 800 X 600 @ 60 KHZ
•
14.1” and 15” monitors
: The native resolution of the LCD panel is 1024 X 768; Recommended resolution is
1024 X 768@ 60 KHZ
•
17” and 19” monitors
: The native resolution of the LCD panel is 1280 X 1024; Recommended resolution is
1280 X 1024 @ 60 KHZ or 1024 X 768 @ 60 Hz.
•
24” Monitors:
The native resolution of the LCD panel is 1920 x 1200; Recommended resolution is 1920 x
1200 @ 60 or 75 Hz.
RELATED DOCUMENTS:
•
0046115
17C3 A/D MCU RE-PROGRAMMING PROCEDURE
