Dynamic Displays, Inc. User Manual Doc: 0048070
1625 Westgate Road 17C3 A/D Series Rev 2
Eau Claire, WI 54073 Glee 17C3 Page #22 of 26
2.
Connect Video and Power to UVI and Flat Panel Monitor
•
Plug the (VGA, SUB-D, 15HD) cable from the (UVI) box to the Flat / Panel monitor.
•
Plug the Power Adapter / Cable (A/C - D/C Power Supply) into the input connector (12 VDC) on the (UVI) box.
•
Plug one end of the DC Jumper Power Cable into the output connector (12 VDC) on the (UVI) box.
•
Plug the other end of the DC Jumper Power Cable into the Flat/Panel (12VDC) input - located on the rear of
Flat / Panel monitor.
•
Determine Video Plug input from your System:
The (UVI) box supports D-SUB or BNC:
•
D-SUB, 15HD (VGA)
•
D-SUB, 9HD (CGA / EGA) TTL
•
BNC (COMPOSITE / SYNC ON GREEN / SEPARATE SYNC / SEPARATE COMP. SYNC)
After the correct input is determined set switch on (UVI) box for the correct input (D-SUB) or (BNC.) Switch located
next to the last BNC on the right.
Universal Video Input Box Specification:
Supported Video Input
BNC Connector; 3/4/5 Wire RGB with Separate Sync, Composite Sync or Sync on Green.
HD15 VGA Standard Connector: Five Wire RGB with Separate Sync, Composite Sync or Sync on
Green.
D-sub 9 Pin: TTL input for EGA & CGA.
Frequency Range
15 to 68 KHz
Input Interface
5 BNC’s
- HD15 (VGA Analog) - 9-pin D-Sub
Power Connectors
+12VDC Input and Loop through Voltage
Power Requirements
12VDC @ .0.25A
Dimensions
8” (L) x 4.3” (W) x 2” (H)
Mounting
VESA 75/100
Construction
Rugged for Industrial Applications
Weight
1 Lb.
Warranty
One Year Limited Warranty
