Dynamic Displays, Inc. User Manual Doc: 0048070
1625 Westgate Road 17C3 A/D Series Rev 2
Eau Claire, WI 54073 Glee 17C3 Page #21 of 26
UNIVERSAL VIDEO INPUT UNIT OPTION
Dynamic Display’s unique Universal Video Input Option was designed to accept a wide variety of non
-standard
legacy video timing formats. It converts the video input signal to a VGA-style video format that is acceptable to most
modern LCD displays. The Universal Video unit has a unique sync discriminator circuit that filters out extraneous
sync pulses found in some legacy video signals. A phase lock loop design supplies sync pulses that are missing in
other legacy video formats.
With the Universal Video Input Option, the user has the choice of switching between two separate video input ports.
The first video input port is a standard HD-15 D-sub connection with fixed 75 ohm termination. The second video
port has five BNC connections; Red, Green, Blue Video, Vertical Sync, and Horizontal/Composite Sync. The input
impedance of each BNC input may be switched between 75 Ohms and Hi impedance for video loop-through
applications.
Either of these two video ports can accept the following video signal format types:
•
Three-wire RS170 and RS343-style analog composite sync-on-green video formats - with and without serrations
and equalizing pulses.
•
Four-wire analog video formats with separate composite sync.
•
Five-wire Red, Green, Blue Video, with separate horizontal and vertical syncs.
In addition to these analog video timings, the Universal Video Input Option also accepts TTL video signals on Port
One via a 9-pin D-sub connector for CGA and EGA monitors.
Connecting The Universal Video (UVI) Box
Follow the instructions below to install the Universal Video Box to your Flat/Panel monitor.
Required tools: #2 Phillips Screw Driver
1.
Mounting The UVI Box:
•
Power down the Flat Panel Monitor and unplug the Power Adapter Cable (A/C - D/C Power Supply) going to
the Flat Panel monitor unit.
•
Unplug the Video Input Cable (SUB-D, 15HD) from your system going to the Flat Panel monitor unit.
•
Mounting the (UVI) Box hardware is determined by which Flat/ Panel monitor you have. The following list is
for Dynamic Displays Flat Panel systems:
a.
15” Flat Panel Plastic Enclosure
8115061: Screw, Metric, Pan Head, Philips Head, Size M 4X8, Quantity of 4
8120030: Washer ,Locking, Number 8, Quantity of 4
b.
19” Flat
Panel Plastic Enclosure
8115032: Screw ,Metric, Pan Head, Philips Head, Size M 3X8, Quantity of 4
8120027: Washer, Locking External, Size 4, Quantity of 4
c.
Rack Mount and Panel Mount
8114455: Screw SEM, Pan Head, Philips Head ,Size 8-32 by 0.375, Quantity of 4
•
Mount the (UVI) box to the VESA 100 mounting holes located on the rear of the Flat / Panel monitor.
