X2810
Electronic OPEN / CLOSED Sign
with Remote Control
Installation Instructions
IN THE BOX
• Sign panel
• Remote control
• 5V Power adaptor
• Chain for hanging sign
STEPS
1. Install chain on both sides of two top rings first.
2. Hang on a 10kg minimum weight suction-cup hook or similar fixing method to hold the OPEN/CLOSED sign at the entrance to your premises.
3. Plug in 5V power plug and switch power on.
4. Follow the guidelines as below.
GUIDELINES FOR OPERATION:
There are four modes of operation:
1. OPEN STATIC
2. OPEN FLASHING
3. CLOSED STATIC
4. CLOSED FLASHING.
Note:
The operation of the remote control takes precedence and overrides the operation of the panel switches. With the FLASH switch to ON position,
the remote control can be used to change to static operation by pressing the STATIC button. With the MODE switch to ON position, the sign will display
OPEN, but the remote control can be used to change the sign to read CLOSED. However, if the main POWER switch on the rear panel is off, then the
unit will not function and the remote control cannot switch it on.
If you want to…
Program the operating mode by switches on
rear of the panel, press:
Program the operating mode by remote
control, press:
Switch on the panel
POWER to ON position
ON/OFF
Switch off the panel
POWER to OFF position
ON/OFF
Flash the word
FLASH to ON position
FLASH
Static the word
FLASH to OFF position
STATIC
Display OPEN
MODE to ON position
OPEN
Display CLOSED
MODE to OFF position
CLOSED
