10
11
• Remove screw from battery cover
with Phillips screwdriver.
• Replace batteries, paying attention to
battery polarity as indicated.
• Replace battery cover and tighten
screw with Phillips screwdriver.
NOTE:
• Use insulated long-nose pliers or small flat head screwdriver when removing
batteries to prevent damage to battery compartment.
• Ensure the battery compartment is not damaged after replacing the batteries.
• Make sure the battery cover is securely fastened once you are done replacing
the batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (Ni-Cd) batteries.
CAUTION:
Batteries used with this product should be kept away from children
who still put things in their mouths. If swallowed, immediately see a doctor and have the
doctor call (202) 625-3333 collect. If you reside outside the US, have the doctor call your
local poison control center.
WARNING:
Please keep batteries out of reach of children. Batteries and screws
also present a hazard to young children. Removal of the battery cover and replacement of
batteries should be performed by an adult without children present.
MAINTENANCE
C
BEFORE EACH RIDE
Before each ride, check your non-electric ride-on and its components against the
following checklist. In addition, if you have a crash or accident, even a minor one,
always inspect the non-electric ride-on toy thoroughly before riding again.
• Check that wheels are straight.
• Check attachment of wheels.
• Inspect your wheel for wear or damage.
• Check the wheels to see if they can spin smoothly.
• Check to make sure that there are no broken or worn parts and that the foot to
floor ride on toy is operating smoothly.
WARNING:
A non-electric ride-on that does not work properly can cause you to
lose control and fall. Inspect the entire non-electric ride-on thoroughly before every ride and
do not ride it until any problem has been corrected.
• Periodically inspect the non-electric ride-on for wear or damage.
• To clean the non-electric ride-on, use a mild soap and water solution and clean
cloth.
• Rinse clean with water to remove soap residue.
• Replace worn parts.
IMPORTANT
• Do not let any child touch the wheels or be near them when the ride-on vehicle is
moving.
• To avoid accidents, please inspect the vehicle before riding to ensure that it is in
proper working order and safe to ride.
• Check all the screws, cap nuts and protective coverings regularly and tighten as
required. Check plastic parts on a regular basis for cracks or broken pieces.
1.5V AA / LR6
1.5V AA / LR6
-
-
+
+
1.5V AA / LR6
1.5V AA / LR6
Screw
BATTERY INSTALLATION
• Remove screw with nut (Type B - Dia.
4mm x 38mm x 1pcs) with Philips
screwdriver and pull out steering
wheel.
Steering Wheel
