dynabook Portege X30L-K Series, Руководство по обслуживанию

Страница: 33 / 136

Maintenance Manual (960-948) 2-11
Troubleshooting Procedures
If you press the key or button, the SETUP screen will appear.
Set the correct date and time. If the following error message
appears often at power-on, replace the battery pack or RTC
battery (if RTC battery is installed).
If any other error message other than below is displayed,
perform Check 2.
(a)**** Date and Time reset to default ****
Press [F2] key to set Date and Time.
(b)**** Date and Time reset to default ****
Press Windows button to set the Date/Time in OS.
(c)**** Date and Time reset to default ****
Press ENTER to set Date and Time.
Check 2
If the following error message is displayed on the screen,
perform Check 3. If any other error message is displayed,
perform Procedure 3.
Insert system disk in drive.
Press any key when ready....
Please check if the Boot Mode is correct in the BIOS
settings.
The BIOS settings menu is launched by pressing the [F2] key
after you reboot.
Check 3
A device without any system information is installed and it may
be designated as the boot device. Remove the device, press
any key and reboot the computer. At the reboot, press F2 to
display the BIOS setup screen. Set the correct boot device and
repeat Procedure 1. If any error occurs or any device is not
installed, go to Procedure 2.
2.4.2 Procedure 2 Diagnostic Test Program Execution Check
Execute the following tests from the Diagnostic Test Menu. These tests
check the system board. Refer to Chapter 3, Tests and Diagnostics for
more information on how to perform these tests.
Table 2-4 Main Test Menu
Test
No
Test Name Sub Test No Sub Test Name
1 MEMORY
1
2 Main Memory Test
V-RAM Memory Test
2 HDD/SSD Test
1
2
3
4
5 Sequential Read Test
Partial Read Test
Address Jump Test
Address Uniqueness Test
Specify Address Test
3 Keyboard Test
1
2 Key-code Test
Touch Pad Test