D Y MA X. COM
W I D ECU RE
®
C ONV EY O R U S ER G U I D E
|
7
Bright, Visible Light
The bright, visible light energy emitted by curing systems can cause eyestrain if proper eye protection or shielding is not used. The
proper use of tinted eye protection and/or opaque/tinted shielding can be utilized to reduce eyestrain and address this concern.
Summary
UV light sources can be more
“worker friendly” than many commonly accepted industrial processes provided the potential
concerns are addressed. Contact your Dymax representative for information regarding the proper use of Dymax UV light-curing
systems.
Unpacking
Inspecting Your Shipment
Your
WIDECURE
light-curing conveyor will arrive in one crate. Inspect the crates and boxes for damage and notify the shipper of
box damage immediately.
Open each box and check for equipment damage. If parts are damaged, notify the shipper and submit a claim for the damaged
parts. Contact Dymax so that new parts can be shipped to you immediately.
Check that the parts included in your order match those listed below. If parts are missing, contact your local Dymax representative
or Dymax Customer Support to resolve the problem.
Parts Included
•
WIDECURE
Conveyor
•
WIDECURE
Conveyor System User Guide
Unpacking Your Shipment
Follow these steps in unpacking the conveyor:
1.
Remove the 4 Lag Bolts that are holding the machine onto the crate.
2.
Remove the Plastic Banding that is wrapped around the machine.
3.
Remove the Bottom Panel from the front of the machine to gain access to the Forklift Pockets (Figure 2).
CAUTION:
Long fork lift forks may require remove of
the unit’s
rear panel to prevent damage to the panel.
4.
Lift the machine using a forklift and place the unit in its permanent location.
CAUTION:
The machine weights approximately 1,200 pounds. Exercise all safety precautions and ensure the forks are
seated sufficiently so the machine will not tip when lifted.
5.
Temporarily remove the 4 blue Corner Trip Pieces. They are magnetically attached and could come loose during movement
and shipping.
6.
With the machine in place, adjust the Leveling F
eet so the machine’s
Conveyor Bed is level and the machine does not rock on
the floor.
