17
Dymax SG-200 High-Flow Spray Gun System User Guide
Connecting the Material Reservoir
A
—
Cartridge Reservoir Systems
Prepare the Cartridge Reservoir
WARNING!
Some Dymax fluids can bond skin together in seconds. It can also irritate skin,
eyes, and mucous membranes. To minimize the risk of bonded skin or irritation, wear protective
gloves and eyewear when working with Dymax fluids and the hand-held spray gun system.
1.
Unscrew the cover from the cartridge reservoir retainer. Remove the empty cartridge reservoir if present.
2.
Remove the plastic cover from the top of a Dymax or other cartridge reservoir.
3.
Place the cartridge reservoir in the retainer so that the fluid outlet at the bottom of the cartridge extends
through the hole in the bottom of the retainer.
4.
Screw the cover back onto the retainer.
5.
To prevent low-viscosity fluids from flowing from the cartridge reservoir when you remove the outlet
plug, hold the retainer upside down.
6.
Unscrew and remove the plug from the cartridge reservoir outlet.
Screw in the supplied 3/8-in. (9.5-mm) fitting into the reservoir outlet until it is just snug; then turn it
about one additional half turn.
NOTE:
Thread tape should be on the threads of the supplied 3/8-in. (9.5-mm) fitting. If the fitting does not
have thread tape installed (or you are reusing the fitting), apply fresh thread tape to the fitting threads to
prevent fluid leaks.
Fluid Line Connections
1.
Connect one end of the fluid line to the
reservoir outlet fitting by pushing the line
into the fitting. Attach the other end of
the fluid line to the fluid inlet fitting on
the spray gun.
2.
Allow the cartridge retainer to hang
freely below the handle. Use securing
clips to harness the pneumatic tubing to
the cartridge. This prevents the cartridge
from swinging freely while spraying, and
keeps lines neat and orderly during use.
Connect Air Line to Cartridge
Reservoir
Connect the material pressure regulator
(air out) to air inlet fitting on the cartridge
reservoir.
Figure 8. Cartridge Reservoir Connections
fluid line
Air line
–
Connects from Material Pressure
Gauge to Cartridge Retainer
