USE R GUI DE
|
BL UE WAVE
®
F X -1 2 5 0
17
Setting the Power
The operation steps are:
1.
On the main window, press the power button (Table 3,
#6) to enter the power window (Figure 20).
2.
Enter the desired value using the pad and press enter.
(10%~100%). The new value will display in the bar.
3.
If no change is needed, press the back arrow in the top
left corner to exit the power window.
Setting the Cure Time
1.
On the main window, press the timer (Table 3, #7) to
enter the cure time window (Figure 21).
2.
Enter the desired value using the pad and press enter.
(0-9999 seconds). The new value will display in the bar.
Set the cure time to 0 sec. to run the emitter until it is
manually stopped.
Set a value greater than 0 sec. to run the emitter
automatically for that duration.
Cure times can be set in intervals of 0.1 sec.
3.
If no changes are needed, press the back arrow in the left
top corner to exit the cure time window.
Running the System
1.
After power and cure time have been set, the emitters can
be run.
2.
Each emitter channel can be operated separately using the
play/stop button (Table 3, #4) on the main window.
3.
To operate all emitter channels together, the run
(Table 3, #10) and stop (Table 3, #9) buttons on the main
window can be used to start and stop the emitters.
Figure 20.
Power Window
Figure 21.
Cure Time Window
