Quick Start Instructions
BlueWave
®
LED Flood Lamp Mounting Stand Kit (41268)
Unpacking and Setup Instructions
1. Remove the stand and carriage from the packaging.
2. Remove the cap and 2 fasteners from the stand’s upright. These are push-in fasteners, not screws, and can
easily be removed by pushing upward on the plate (Figure 1).
3. Using a 2-mm hex key, remove the 2 outer screws from the back of the emitter. (Figure 2)
Figure 1. Remove Cap and Fasteners
Figure 2. Remove 2 Outer Screws from Emitter
4. Using a 4-mm hex key, attach the carriage to the emitter using the screws supplied with the carriage. (Figure 3)
5. Slide the carriage onto the stand upright, being sure to align bearing pads and t-nut into slot (Figure 4).
Figure 3. Attach the Carriage to the Emitter
Figure 4. Slide Carriage into Stand
Stand’s Upright
Cap
Fasteners (2X)
Remove 2 Outer Screws
