Customer Service 1-888-707-1880
Dyaco Canada Inc. 2018
Email: [email protected]
21
SERVICE CHECKLIST - DIAGNOSIS GUIDE
Before contacting us for aid, please review the following information. It may save you both time and
expense. This list includes common problems that may not be covered under the treadmill’s warranty.
Problem Meaning Solution/Cause
Console
Showing LUBE
Reminder to check
lubrication under
walking belt
1. Check lubrication under walking belt.
Reference belt deck lubrication procedure on page 18.
2. Hold ENTER button for 3 seconds to reset
Console
Showing E1
Console shows E1
8~10 seconds after
pressing “Start” button.
1. Does the motor run after “Start” button is pressed?
2. Check the cable connecting the console and controller for
proper connection.
Console
Showing E0
Safety Switch
Malfunction
1. If safety key switch is placed properly?
2. Is safety harness to the console connected properly? Any
connector damaged?
3. Is safety switch defective?
Console
Showing E2
Over Current
Protection
Treadmill over loaded,
controller protection
is activated.
1. Check for proper walking belt alignment. Make sure to
lubricate belt periodically to minimize resistance.
2. Is there any bearing damage?
3. Has the motor overheated?
Console
Showing E4
Improper Motor input
voltage.
Motor is not
connected properly.
1. Motor is not connected properly or not connected to the
controller.
Console
Showing E5
Communication
disconnected between
the console and
the controller or
communication error
1. Check for proper connection between the console and
controller.
Console
Showing E6
Controller Malfunction
1. Controller component failure
Console
Showing E7
Abnormal Power Input
1. Check for proper voltage input for treadmill.