DWT 742432, Оригинальное руководство пользователя

Страница: 9 / 60

9
English
• During operation stand aside from the plane of
rotation of the cutting disc.
• During operation watch the position of a power cable
(it should always be positioned behind the tool). Do not
allow it to whip around your legs or arms.
• Never start cutting until the cutting disc reaches its
full speed.
• When processing small blanks, use clamping
devices. If the blanks are too small to be fixed properly -
do not process them.
• Always process only one blank - this is the only way
to fix it properly.
• While processing long blanks use the clam ping
devices and be sure to provide a support under the
long end of the blank. Never make a third person hold
the working blank.
• If during operation the cutting disc gets stuck in the
blank or is blocked, immediately switch off the power
tool and only then eliminate the cause of the cutting
disc failure.
• Dust generated during operation may be a hazard
to your health, inflammable or explosive; clean your
working place in time and use means of individual
protection.
• Operation may produce sparks and small
particles, which can cause injury to the operator or
to the bystanders. Always wear means of individual
protection (goggles and protective mask), as well as
arrange your working place in a proper way.
• Mind power tool backflow (sudden backward push)
that may occur in case of deviation from operating
conditions (for misalignment or jamming of cutting disc
in the cut).
• Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
• Avoid stopping the power tool motor when under
load.
• Avoid overheating your power tool, when using it for
a long time.
• Never operate the power tool over your head level.
After finishing operation
• The power tool can be removed from the workplace
only after the cutting disc has been switched off and
stopped completely.
• Never try to slow down the inertial rotation of the
cutting disc by applying effort to the cutting disc lateral
surface.
• The cutting discs can get very hot during operation -
do not touch them until they have cooled down.
Symbols used in
the manual
Following symbols are used in the operation manual,
please remember their meanings. Correct interpretation
of the symbols will allow correct and safe use of the
power tool.
Symbol Meaning
Serial number sticker:
MS ... - model;
XX - date of manufacture;
XXXXXXX - serial number.
Symbol Meaning
Read all safety regulations
and instructions.
Wear safety goggles and ear
protectors.
Wear a dust mask.
Disconnect the power tool
from the mains before instal-
lation or adjustment.
Movement direction.
Rotation direction.
Locked.
Unlocked.
Prohibited.
Double insulation / protec -
tion class.
Attention. Warning of possi-
ble user health damage.
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo -
nized EU standards.
Attention. Important.
Wear protective gloves.
During operation, remove
the accumulated dust.