13
3.4 Auto scan
The ‘auto-scan’ feature supports up to 17 programmed angles at user-programmable
speeds.
AUTO SCAN SETUP
NUMBER : 01
TITLE : A01
MODE : NORMAL
SPEED : 5 STEP
START ANGLE : ----- ----- --
END ANGLE : ----- ----- --
SCAN DIR : CCW
SWAP : OFF
DWELL : 03 SEC
FOCUS : AUTO
SAVE AND EXIT(ESC TO CANCEL)
•
NUMBER 01 ~ 08, 10 ~ 17, 09: auto-pan mode (endless panning).
•
TITLE
Up to 6 characters.
•
MODE
Normal, vector, random (auto-pan mode: normal, random only).
-
NORMAL
Move from the start point to endpoint in panning only.
-
VECTOR
Move from the start point to endpoint including tilt and zoom
simultaneously and linearly.
-
RANDOM
Move randomly between the start point and the endpoint.
•
SPEED
1 ~ 13, the lower the number the slower the speed.
•
SCAN DIR Set the scan direction, CCW (counter-clockwise) or CW (clockwise).
•
SWAP
Swap the start point for the endpoint.
•
DWELL
Set the dwell time at both ends, 01 ~ 99 seconds.
•
FOCUS
Set to auto or manual.
To program the camera to ‘Auto Scan’:
1.
Press the MENU key to display the camera’s menu options. Select the ‘Auto Scan’
sub-category and press the Right key.
2.
Select “NUMBER” and set the desired number by pressing the Right or Left key.
3.
Select “TITLE” and press the Tele or Wide key to enter the title edit mode.
4.
Press the Tele or Wide key to change the alphanumeric characters and move the
next position by pressing the Right or Left key. Or move down to the character
table and press the IRIS Open key at the desired character then the cursor
position moves to the next position automatically. Press the Right or Left key at
the “ALL DELETE” field to delete all characters. Press the Right or Left key at the
“EXIT” field to finish the title edit menu.