DVTEL CT-5322F, Руководство пользователя и инструкция по установке

Страница: 21 / 88

Camera Installation and Mounting
7

BNC crimping tool
Figure 5: Recommended Tools
3.3 Attach the Base Mount to the Camera
To attach the base mount to the camera
1. Screw the base mount into the camera body with eight #6 screws.
Figure 6: Attaching the Base Mount
2. Using the electric screwdriver, tighten the fasteners to about 8 inch-pounds (0.904 newton meters)
of torque.
3. Using the electric screwdriver and the Torx T10 security bit, tighten the fasteners to about 10 in-lbs.
(1.23 newton meters) of torque.
3.4 Connecting the Camera Cables
In order to connect the camera to the network, take the analog video cable, network cable, power supply
leads (if an AC or DC supply is used), and alarm, relay, and RS-485 wiring (if used) from the wall at the
installation site.
In order to connect the wires to the connectors on the camera’s connector panel, they must be wired
through the supplied cordgrip. Wires must be fed from the wall through the camera’s mounting assembly,
through the opening on the underside of the camera, through the camera body, and out of the opening on
the camera’s connector panel. The wires then must be attached to connectors before attaching them to the
connector panel.