DVS SpycerBox Flex, Руководство по оборудованию

Страница: 14 / 84

Introduction
 Safety Instructions
1-6
SpycerBox Ultra/Flex | Hardware Guide | Version 3.1
Rohde & Schwarz DVS GmbH
1.4 Safety Instructions
To use the SpycerBox correctly please heed the following:
General
The SpycerBox has been built according to the applying safety regula-
tions. To minimize the possibility of a faulty operation of the device all
manuals and guides must be available at all times at the operation site.
Before installing and/or using the R&S DVS system the manuals and
guides delivered with it must be read and observed.

Use the R&S DVS system only in apparent good technical order.

The hardware of the R&S DVS system works with voltages that can
be hazardous to your health. Never work on the system or access
its interior with the power cable(s) being plugged in. Make sure the
power supply is disconnected from the components you intend to
work on.

Computer hardware contains components that are sensitive to elec-
trostatic discharge. If you touch them without precautionary mea-
sures, they can be destroyed. Use a wrist strap connected to
ground when accessing electronic parts and take care of grounding
the system. Avoid touching the internal components of the R&S
DVS system whenever possible.

Computer hardware contains components that are sensitive to
changing voltages. Connecting or disconnecting the R&S DVS sys-
tem to or from peripheral hardware while any of them is switched
on may damage the hardware. Switch off all peripheral hardware
before connecting or disconnecting anything.

Use, store and transport the R&S DVS system only in compliance
with the technical data laid out in section “Technical Data” on
page A-5.

If fluids or solid objects get inside the casing, the R&S DVS system
must be disconnected from the power supply immediately. Before
using the R&S DVS system again, it has to be checked by autho-
rized service personnel.

Only use a damp tissue without any cleaning agents to clean the
casing.
Noncompliance with safety instructions
If the R&S DVS system is not used in compliance with the safety
instructions, the warranty and all resulting liability claims will be
void.
Please read the following safety instructions carefully be-
fore attempting any installation and/or performing any work
on the SpycerBox hardware.