DVS Pronto4K, Руководство по оборудованию

Страница: 46 / 74

5-6
Pronto4K Hardware Guide
interface inside the system and until the lever retracts by itself from
the pushing.

Then simply close the lever until it snaps back in place which as a
result will slide the carrier completely back in.
Once the faceplate of the DVS system is back in place, the replacement
of the hard disk is finished. After several minutes the replaced hard disk
will be automatically recognized by the system. Then the rebuild of the
data will be initiated on its own. When the system has finished the re-
build, the DVS system will be fully operational again.
It is important that you do not use the lever to insert the
disk carrier. Apply an even pressure only to the carrier di-
rectly until the lever moves back by itself.
The disk carrier of the replaced disk should be level with the
others of the array.
During a rebuild real-time processes may not be possible. It is
recommended to restrict accesses to the hard disk array until
the rebuild is finished.
A rebuild takes several hours. It is strongly recommended to
avoid accesses to the disk array during this time, otherwise it
may take considerably longer.