DVS Pronto4K, Руководство по оборудованию

Страница: 25 / 74

2-7
Overview
2
1
3
I
4
5
A
Each hard disk of the array is connected to the system with the help of
a disk carrier which makes the removal of a hard disk from the system
easy, for example, in the event of a failure.
Figure 2-8: Hard disk carrier overview
2.1.6 DVD Drive
The system is equipped with a DVD drive which can be used for service
purposes or to install additional software. It also provides burning ca-
pability.
The hinge wires hold the faceplate in place and allow you to lift
it. For further information see section “Faceplate” on page 2-5
and section “Removal of the Faceplate” on page 5-14.
Further information about how to remove and exchange a hard
disk can be found in section “Hard Disk Maintenance” on
page 5-2.
disk carrier The disk carriers hold each one hard disk of the
array. The hard disks are mounted to the disk
carriers with several screws normally located at
the sides of the carriers.
lever Once the lever is unlatched with the opener, it
can be used to pull the disk carrier and its hard
disk out of the system.
opener Unlatches the lever and with it the disk carrier.
LED disk power Shows whether the disk of the disk carrier re-
ceives power.
LED disk activity Indicates the status of the hard disk of the disk
carrier (see also section “HDD LEDs” on
page 2-4):
off Hard disk is idle.
green Hard disk is accessed.
red A hard disk or hard disk carrier related
error has occurred.
lever opener disk carrier
LED disk
LED disk
activity
power