DVS Atomix LT, Руководство по установке

Страница: 41 / 72

3-7
Installation
3
2
1
I
4
A
Connecting the Audio Panel(s)
Depending on your setup the audio panel(s) can be installed as audio
panel #1 and/or audio panel #2 (see section “Note About the Audio
Setup” on page 2-10). The connections are made with 26-pin flat ca-
bles to the Atomix LT board. To perform the internal connections you
can connect the audio panel(s) to the board as shown in the following
figure:
Figure 3-4: Internal connections of the audio panel(s)
Prior to the installation of the panels you have to set/check the
jumpers on their printed circuit boards for the appropriate set-
tings (see section “Jumper Settings of the Audio Panel(s)” on
page 3-4).