DVS Atomix LT, Руководство по установке

Страница: 39 / 72

3-5
Installation
3
2
1
I
4
A

In the computer system remove the slot bracket from the PCI slot
where the Atomix LT board should be installed.

Insert the Atomix LT board into the PCI slot without using excessive
force or bending it.

Afterwards fasten the board with the screw from the slot bracket.
With this the Atomix LT board is installed in the computer system and
you can move on to the next step, i.e. to the installation of the panels.
3.1.3 Installation of the Panels
As the third step you have to connect the delivered panels internally to
the Atomix LT board and install them in your computer system. For this
perform the following:

Remove as many slot brackets as you need for the additional pan-
els.

Now install the panels: Insert the panels of Atomix LT into the
empty slots and fasten each with a screw from the slot brackets.

Connect the cables to the appropriate Atomix LT board interfaces as
detailed in the following:
The Atomix LT board must be installed in a PCIe x8 or x16 slot
(four or more electrical lanes).
During the next step please observe not to break off any parts
of the PCI video board. Apply pressure to the slot panel and/
or the printed circuit board only, not to any of its attached
parts.
The chassis of the computer system where the Atomix LT
board is installed must be equipped with a sufficient ventila-
tion for cooling reasons.