Dust Networks SmartMesh IA-510 D2511, Руководство для руководителей

Страница: 23 / 30

S
MART
M
ESH
IA-510 D2511 M
ANAGER
G
UIDE
17
A
Configuring Serial 1
Operation
The Serial 1 interface on manager can be used for a PPP, manager serial API, manager
CLI, or Linux shell connection. Refer to the
SmartMesh IA-510 Manager Serial API
Guide for information on how to log in to these processes.
This appendix provides instructions for configuring the Serial 1 interface using the
Admin Toolset utility on manager or Linux commands.
Configuring the Serial 1 Interface
To connect the Serial 1 interface to a PC or control device that uses a 9-pin D-SUB
RS232 port, an RJ45 to 9-pin D-SUB adapter is required. Appendix B provides
instructions for assembling the adapter.
b
Important: The Serial 1 interface is intended for local serial connections only.
Because no authentication is performed, use it only in a trusted environment.
Using Admin Toolset to Configure Serial 1
To configure Serial 1 for PPP:
A
Connect your computer to the manager:
•
If the manager is installed on the LAN, connect your computer to the LAN.
•
If the manager is not installed on the LAN, connect your computer directly to the
manager using an Ethernet cross-over cable. The manager default IP address is
192.168.99.100. You can change your computer IP address to 192.168.99.101 to
be compatible. For more information, see “Connecting the Manager Directly to a
Computer” in Chapter 3.
B
Open Internet Explorer. In the URL address field, type in the IP address of the
manager.
C
If a security alert displays indicating that there may be a problem with the site
security certificate, take the action required to proceed to the website (the site is