Fig. 5: Setting air flow
2. Set air flow.
Set air flow control lever (A) to “min-
imum”.
Increase flow slowly.
You can regulate the air continu-
ously from “minimum” (A) to
“maximum” (C).
3. Set the spray width by turning the flat jet
setting (1).
Right turn: Min. flat jet
Left turn: Max. flat jet
You can turn the flat jet continu-
ously 270
°
and adjust the spray
from flat to round jet.
Characteristic curves
The characteristic curves show the air flow
depending on the air pressure
Fig. 6: Characteristic curve
CF Conventional air cap
LF Air cap LVLP
6
Operation
6.1
Safety recommendations
WARNING!
Danger of explosion due to chemical
reactions
Material, halogenated hydrocarbon-based
rinsing agent or cleaning agent can chemi-
cally react with aluminum components of
the product. Chemical reactions can
cause explosions. Serious injuries and
death can be the consequence.
– Only use rinsing agents and cleaning
agents that do not contain any halo-
genated hydrocarbons.
NOTICE!
Material damage due to dried material
residues
If material residues dry in the product, that
can harm components.
– Rinse product immediately after each
use.
Operation
05/2018
EcoGun 910 - MSG00003EN
9/32
