Durr Dental 5286100036, Инструкция по установке и эксплуатации

Страница: 24 / 36

Usage
12 Operation
Prior to working on the unit or in case of
danger, disconnect it from the mains.
12.1 Operating panel
1
2
3 4
5
1 Pressure range display/adjustment
2 Service key with blue LED
3 Standby button with blue LED
4 Filter change button with orange LED
5 Fault button with orange LED
Different messages and the status of the unit are
displayed on the operating panel. In addition, dif-
ferent functions can be started via the buttons.
Buttons
Fault button Display of alarm messages
with different levels of
importance. This can be
faults, warning messages
and information.
Filter replacement
button "Maintenance required" dis-
play for the various filters.
Service key Check of the safety valve
and adjustment of the pres-
sure range.
Standby button: Switching between normal
operation and standby
mode.
Pressure range
The pressure is displayed and can be adjusted in
this area.
The pressure is displayed via:
1. Blue LED (
£
4.5 bar):
only illuminates while the pressure is building up
during start-up operation
2. - 10. Blue LEDs (= 5 - 9 bar):
these indicate the pressure status in increments
of 0.5 bar
11. Blue LED (
³ 9.5 bar):
the pressure in the container is too high (i.e. out-
side the adjustment range).
12.2 Switching the unit on/off
❯
Switch the unit on and off via the surgery main
switch.
The compressor unit will start up automatically
and fill the pressure tank. When the cut-off
pressure is reached the compressor unit
switches itself off automatically.
12.3 Standby mode
In standby mode the appliance is taken out of
operation without disconnecting it from the
mains.
❯
Press the standby button for at least 2 sec-
onds.
The standby button and service key are active.
Normal operation is reactivated with the
standby button.
The system can switch to setting mode with
the service key. To do so, press the service key
for
at least 2 seconds.
12.4 Fault
The controller monitors the functions of the unit
and signals faults according to their importance.
Faults, warnings or information can be displayed.
Faults are triggered as a result of faults in com-
ponent assemblies or as a result of sensor
defects. The device is switched off and the LED
of the fault button flashes or lights up.
Fault button, orange LED flashes
Normal mode or emergency mode can be acti-
vated.
Fault button, orange LED lights up
As well as faults, the LED on the fault button also
lights up to indicate warning messages and infor-
mation.
The device continues to operate in normal mode.
Usage
22 5286100072L02 1909V005
EN