Page 26 from 37
It gets too hot in the house
This can have several causes:
The stove has too much power in P1. This is the cause in most cases, there is
nothing wrong with the stove. This means that in a small and/or well-insulated
room, the temperature will continue to rise as long as you leave the stove on. If
you don't want the temperature to rise further, provide adequate ventilation or
turn off the stove.
8 Read and reset error
The stove is equipped with a series of sensors
and control mechanisms to ensure the safe
operation of the unit.
In case of an error of any of these control
mehanisms, an error will be recognised by the
stove controller. In case of an error, the STATE
LED turns red and starts flashing.
The
FAULT CODE
can be read by counting the number of flashes.
Check the error list for the error code corresponding to the number of flashes.
After the fault has been recognised and the source problem resolved and fixed,
the alarm on the controller can be reset by pressing the button once.
The
STATE LED
turns green for 2 seconds to confirm the reset.
9
Fault messages and
solutions
9.1.1
ERROR 1
No ignition, this message is given when there is no ignition. (see 7.2)
9.1.2
ERROR 5
No pellets. Flue gas temperature is too low. Possible causes:
•
The tank is empty. Fill the reservoir with pellets.
•
There is a defect (see 7.1)
Содержание Batavia T4
