Step 1:
Insert and tighten the Dyna-
Stud into a threaded receptacle of the
corresponding size. A locking jam nut
is recommended to prevent the Dyna-
Stud from turning. *If using Drop-In
see instructions below.
®
End Fixings Installation Instructions
Swaged
Dyna-Stud
*When using Dyna-Stud Drop-In
(sold separately)
:
Before
starting
to drill the
hole, it is
important
that eye
and ear
protection
are used.
Step 1:
Insert a carbide tip
masonry bit into the ham-
mer-drill chuck and tighten
it in place. The depth of
the hole to be drilled can
easily be set by using the
depth gauge on the drill
or by wrapping the bit with
tape at the required depth.
Make sure that the hole
depth will allow the anchor
to be flush with the surface
of the concrete.
Step 2:
Make sure the
hammer drill is in the
hammer mode and start
drilling your hole. Continue
drilling until the tape on the
bit or the drill gauge meets
the base material - this
means that the required
depth has been reached.
Step 3:
Before proceeding
with installation, the hole
must be cleaned of all
concrete dust to ensure
proper fastening. Use a
wire brush, a vacuum or
compressed air to clean
out the hole completely.
Step 4:
Next, insert the
drop-in anchor with the
open side up. Drop the
anchor into the hole. Tap
lightly to get the anchor
flush with the base
material.
Step 5:
Now, take the
setting tool and insert
it into the anchor.
Strike the setting tool
with a hammer until
the lip of the anchor
touches the lip of the
setting tool. This will
ensure the anchor is
properly set.
CAUTION
Step #1:
Pass the end of the wire rope
around the anchor point and through
the cable loop.
Step 2:
Using the appropriate cable lock
(see the chart on back), pull adjustment
pin back and pass the end of the wire rope
through the Dyna-Tite Cable Lock.
Looped Cable
Assembly
Eyelets
Step 1:
Attach the wire rope to
a convenient anchor point with
appropriate fastener.
Step 3:
Loop the wire rope around the duc-
twork or through attachment bracket and
back up through the Cable Lock.
ALWAYS CONFIRM ENGAGEMENT OF CABLE LOCK ON WIRE BEFORE APPLYING LOAD
'L'
'L'
'L'
1-1/2"
(LISTED)
CABLE
(LISTED)
45° EYELET
(LISTED)
CABLE
90° EYELET
(LISTED)
(LISTED)
CABLE
BRACKET w/DRIVE PIN
'L'
'L'
'L'
1-1/2"
(LISTED)
CABLE
(LISTED)
45° EYELET
(LISTED)
CABLE
90° EYELET
(LISTED)
(LISTED)
CABLE
BRACKET w/DRIVE PIN