Dürkopp Adler 667 PREMIUM, Инструкция по эксплуатации

Страница: 81 / 150

Programming
Service Instructions 667 PREMIUM - 03.0 - 01/2018 79
14.6.3 Setting the Speed (
Speed
) parameter
Various settings can be made for the speed. The possibilities are explained
in more detail in the table.
14.6.4 Setting the Stop positions (
Stop Positions
) parameter
Various settings can be made for the stop positions. The possibilities are
explained in more detail in the table.
Menu item Setting options
Max Speed
Maximum permissible speed; it can no longer be exceeded on the
operator level.
(Value range 0500 - 3800 [rpm], depending on the subclass)
Min. Speed
Minimum speed at which an individual stitch is made; a lower speed is
no longer possible at operator level.
(Value range 050 – 400 [rpm])
Pos. Speed
Position speed; the last stitch is made slower during stopping of the
sewing procedure.
(Value range 010 – 700 [rpm])
Soft Speed
Speed for the soft start.
(Value range 0010 – 1000 [rpm])
N Stitches
Number of stitches to be made during a soft start.
(Value range 00 – 10)
Acceleration
Slope of the acceleration ramp
(Value range 10 - 40 [rpm/ms])
Deceleration
Slope of the deceleration ramp
(Value range 10 - 40 [rpm/ms])
Menu item Setting options
StopBottom°
Holding position of the needle in the material.
Value range (000 – 359)
Threading°
Position for the proper function of the threader, e.g. with thread lever
at top dead center.
Value range (000 – 359)
StopTop°
Holding position of the needle outside of the material.
Value range (000 – 359)
StopIdle°
Stop position after thread cutting (reversal position).
Value range (000 – 359)