DURKOPP ADLER 869-M Premium, Инструкция по эксплуатации

Страница: 101 / 180

Programming
Service Instructions 869-M PREMIUM - 00.0 - 07/2018 99
19.6.2 Setting the Thread clamp (
Thread Clamp
) parameter
Various settings can be made for the thread clamp. The possibilities are
explained in more detail in the table.
StitchLengthChg
On/Off
Optimization of the remaining thread length for the cutting systems
(KFA = 1, extra short; LFA = 10, extra long)
St.Length
(Value range 01 – 10)
On°
(Value range 000 – 359 [°])
Off°
(Value range 000 – 359 [°])
Trim Backward
Thread cutting during backward stitch.
(Value range: On/Off)
PWM Config
Pulse width modulation
Power supply to the magnet for the thread cutter.
t1 [ms]
Activation duration of the thread cutter in time period t1.
(Value range 000 – 1000 [ms])
DtyC. t1 [%]
Duty cycle in time period t1
(Value range 000 – 1000 [%])
t2 [s]
Activation duration of the thread cutter in time period t2.
(Value range 000 – 1000 [ms])
DtyC. t2 [%]
Duty cycle in time period t2
(Value range 000 – 1000 [%])
Menu item Setting option
Menu item Setting options
Mode
Various modes (1 to 10) are available; explanations can be found
in the

Parameter list 869-M PREMIUM
.
Mat.Thickness
Compensation of the material thickness
(Value range: On/Off)
Clamp Angle
On/Off
Position for activating and deactivating the thread clamp.
(Value range 000 – 359)
Foot Angle
On/Off
Position for lifting/lowering the sewing feet, to release a thread
jammed underneath.
(Value range 000 – 359)
Height
Lifting height of the sewing feet.
(Value range 01.0 – 12.0)