DURKOPP ADLER 610-10, Руководство по эксплуатации

Страница: 57 / 148

Settings via software
Operating Instructions 610-10/630-10 - 01.0 - 01/2021 55
Middle pane (3)
This pane holds the symbols of all parameters that can be set in
MAN operating mode as well as the display of the path length
already sewn in mm The gray fields above the parameter symbols
show the respective current values.
Right pane (4)
Another user interface or another operating mode can be selected
here.
5.4.1 Parameters that can be set
The following table lists the parameters that can be set in AUTO
operating mode.
Symbols/buttons Meaning
Program selection,

p. 56
Select the right or left piece to be sewn
Set the sewing material size,

p. 57
Other program parameters in operating
mode
AUTO ,

p. 60
Temporarily setting the fullness value until
the next sewing step,

p. 58
Applying a % correction to the fullness val-
ues of all sewing steps,

p. 59
Setting the needle thread tension.
If changed in
AUTO operating mode, the
value is permanently saved in the sewing
program.