background image

Warranty

DuraTrax will warranty this kit for 90 days after the purchase date from defects in materials or workmanship. DuraTrax will either repair
or replace, at no charge, the incorrectly made part.

Make sure you save the receipt or invoice you were given when you purchased your model. It is your proof of purchase and we must
see it before we can honor the warranty.

To return your Mini Quake for repairs covered under warranty you should send your model to:

Hobby Services

3002 N. Apollo Drive Suite 1

Champaign, Illinois 61822

Attn: Service Department

Phone: (217) 398-0007 9:00 am-5:00 pm Central Time M-F

E-mail:

[email protected]

If the buyer is not prepared to accept the liability associated with the use of this product, the buyer is advised to return this
kit immediately in new and unused condition to the place of purchase.

READ THROUGH THIS MANUAL BEFORE STARTING CONSTRUCTION. IT CONTAINS IMPORTANT
INSTRUCTIONS AND WARNINGS CONCERNING THE ASSEMBLY AND USE OF THIS MODEL.

© Copyright 2004

DTXZ1109 For Kit DTXD11**

ASSEMBLY AND OPERATION MANUAL

Length: 9.5" [240mm]
Width: 7.4" [185mm]
Height: 4.7" [120mm]
Weight: 25 oz [725g]
Ground Clearance: 1.25" [32mm]
Radio: 2-Channel

Technical Support Information

For technical assistance, contact:

DuraTrax Product Support

3002 N. Apollo Drive, Suite 1

Champaign, IL 61822

(217) 398-8970, Ext. 5

[email protected]

®

Содержание Mini Quake

















Отзывы: