DuraLabel 4 TTP, Руководство пользователя

Страница: 29 / 31

4) Put the black bar back on the cutter mechanism and line the holes up to be able
to put the 2 screws with the washers back in place.
5) Screw the 2 screws with the washers back in the cutter mechanism.
6) Affix the cutter mechanism back on the machine with by the 2 hooks on pg. 49,
step 5.
* Make sure the wires are between the 2 protruding lips of the black bar, otherwise
it will pinch the wires.
Figure 5. Wires are in between the 2 protruding lips of the black bar.
55
2) Match the holes in the cutter with the holes in the gray casing/lid of the cutter
mechanism.
* Make sure the wires are not in front of the holes.
Figure 3. Holes are clear of any wires.
3) With the wires and yellow “CAUTION” label facing down and holes lining up, care-
fully put the cutter back in the gray casing/lid of the cutter mechanism.
Figure 4. Wires are in between the 2 protruding sides of black bar.
54