DURAG D-R 290, Руководство по эксплуатации

Страница: 21 / 202

2 | Safety
D-R 290 21
Safety
Before starting any work, read the operating instructions!
In this section we give you important instructions for your safety. We point out how you
can avoid hazards that may affect the life and health of the personnel and cause dam­
age to the device and other equipment. Compliance with these instructions contributes
to problem-free operation.
If you fail to take note of these instructions, the DURAG GmbH may not be made lia­
ble for damage caused as a result of negligent or intentional disregard of the informa­
tion provided in these instructions!
General safety instructions
The product Dust and Opacity Monitor D‑R 290 from DURAG GmbH has been de­
signed and built using state of the art technology and complies with the recognised
safety regulations. Despite this, hazards can arise.
Operate the product only when it is in good working order, and in compliance with the
manual. Any abnormal change to normal operation should be taken seriously as an in­
dication of impaired functionality.
In this regard, pay attention to:
●
emission of smoke or unusual smells
●
unusual noises resulting from and during operation of the device (including for in­
stance the purge air blower),
●
unusual vibrations,
●
excessive temperatures of system components,
●
changes in power consumption without obvious cause
●
the tripping of monitoring devices,
●
abnormal, strong fluctuations or shifts in the measurement results.
Use other than in accordance with the designated use or handling can result in health
hazards or material damage. Follow the instructions for all actions on the product
D‑R 290 and the safety instructions and warnings in the individual sections of this
manual.
The following warnings and safety instructions apply in full to the product described:
●
When preparing and performing work:
Observe the legal requirements applicable for the system and the corresponding
technical regulations. Comply with national safety and accident prevention regula­
tions.
●
Work in accordance with:
… the local, plant-specific conditions,
… hazards caused by operational processes
… the specifications.
●
This manual is an integral part of the product and must be kept in the immediate
vicinity of the device, accessible to all staff. Ensure compliance with the instruc­
tions set out for avoidance of hazards and damage.
●
Suitable protective mechanisms and personal protective equipment must be avail­
able in sufficient quantities and used by the personnel in accordance with the rele­
vant potential hazards.
●
The device may only be operated when in good working order, and in compliance
with the safety instructions!
●
The device as a whole and also its individual components may be used only when
in their original configuration.
2
2.1