- 16 -
2.
Repeat step 1, adjust the screw on the right side. Must determine the adjustment screws
the same distance, so that the rear drum will adjust relatively parallel to the frame
。
3.
Repeat steps 1 and 2 until running belt does not slip
。
4.
Note that the running belt not adjusted too tight. This bad run, additional pressure on
the front/rear drum, roller bearings and other damage, resulting in abnormal noise or
other problems
。
If you want to reduce the running belt tension please rotate the wrench counterclockwise,
attention to the left and right to rotate the same distance.
Adjusting the belt in the middle
When you use a running machine, because running feet of power is not as big as the pressure
imbalance on the running belt, resulting in running off center. This deviation is normal, when
no one is in operation on the running belt while running, it will come back to the Center. If not
back to the Center, you will need to run back to the Center
。
1.
No-load running the treadmill, speed 6km/H
。
2.
observe the running distance to the left and right side
⚫
If the left, using the hex wrench, turn the left screw 1/4 clockwise circle
⚫
If the right, using a hex wrench, turn the right screw clockwise 1/4
⚫
If the running belt is still not in the Middle, and repeat the action until adjusted to
an intermediate
3.
After adjusting running belt to the Middle, set the speed to 16km/H, and watch the
running belt deviation and running smooth, if biased, repeat adjustment steps
。
4. WARING
！
Do not tighten the drum excessive
！
This will lead to permanent damage of
bearing
！
If the above steps do not work, you will need to run and then tighten.
T:tight L:loosen
Lubricant
Treadmill factory-over when the lubricating oil. But check the lubrication of running, which