Dura-Trel Inc.
~ PO Box 122, Sheboygan Falls, WI 53085 ~ Toll Free 877-258-6020
TOOLS NEEDED
Drill with #2 Phillips Bit or
Phillips Screwdriver
Super or Crazy Glue
C
AMELOT
P
LANTER
A
RBOR
S
EAT
assembly INSTRUCTIONS
Note:
Camelot
Planter Arbor
sold separately.
SEAT ASSEMBLY
(Refer to Drawing 1)
On a clean flat surface lay the three 1 ½ x 5 ½ x 54” rails with pilot holes facing up. Set the 14”
brackets over rail lining up brackets with the pilot holes. Fasten loosely with
¾”
screws.
Apply household glue to inside of the 7/8 x 1 ½” end caps and slide onto the ends of 7/8 x 1 ½ x
16 ½” center brace. Set the 7 /8 x 1 ½ x 16 ½” center brace in place over pilot holes, fasten with
the
2”
screws.
Apply glue to the inside edges of the 7/8 x 1 ½ x 17” end cap and push end cap onto edge of seat
(do not slide from end), sliding the end cap under bracket as you do. Tighten all the ¾" screws on
brackets.
Seat is now ready to set between the two large planter boxes.
If you encounter missing or defective parts, please contact manufacturer direct at
toll free # below.
