Dura-Trel, Inc. ~
PO Box 122, Sheboygan Falls, WI 53085 ~ Toll Free 877-258-6020
SEAT ASSEMBLY
(Refer to Drawing 1)
Lay the two 48” seat rails on clean, flat surface with pilot holes facing up. Set the brackets over
pilot holes in rails, with the flanged side of the bracket toward center of seat. Fasten brackets to
seat rails with ¾” screws. Slide end caps over ends of seat, end caps will slide between bracket and
rails. You may apply household glue to inside of end cap if needed.
Place planter seat between two planter boxes by setting brackets over the edge of both planters.
If you encounter missing or defective parts, please contact manufacturer direct at
toll free # below.
#11130
P
LANTER
S
EAT
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED
Drill with #2 Phillips Bit or
Phillips Screwdriver
Super or Crazy Glue (optional)
