Duplomatic EWM-2SS-DAD/22E-PN, Руководство для стартапов

Страница: 5 / 50

EWM-2SS-DAD/22E-PN 89475/119 ETM
Duplomatic MS ▪ EWM-2SS-DAD/22E-PN Start-up Manual – 89475-PN/119 ETM --- Mar 2019
5
Safety instructions
Please read this document and the safety instructions carefully. This document will help to define the
product area of application and to put it into operation. Additional documents (EWMPC/20 for the start-up
software) and knowledge of the application should be taken into account or be available.
General regulations and laws (depending on the country: e.g. accident prevention and environmental
protection) must be complied with.
These modules are designed for hydraulic applications in open or closed-loop control
circuits. Uncontrolled movements can be caused by device defects (in the hydraulic module
or the components), application errors and electrical faults. Work on the drive or the
electronics must only be carried out whilst the equipment is switched off and not under
pressure.
This handbook describes the functions and the electrical connections for this electronic
assembly. All technical documents which pertain to the system must be complied with
when commissioning.
This device may only be connected and put into operation by trained specialist staff. The
instruction manual must be read with care. The installation instructions and the
commissioning instructions must be followed. Guarantee and liability claims are invalid if
the instructions are not complied with and/or in case of incorrect installation or
inappropriate use.
CAUTION!
All electronic modules are manufactured to a high quality. Malfunctions due to the failure
of components cannot, however, be excluded. Despite extensive testing the same also
applies for the software. If these devices are deployed in safety-relevant applications,
suitable external measures must be taken to guarantee the necessary safety. The same
applies for faults which affect safety. No liability can be assumed for possible damage.
Further instructions
•
The module may only be operated in compliance with the national EMC regulations. It is
the user’s responsibility to adhere to these regulations.
•
The device is only intended for use in the commercial sector.
•
When not in use the module must be protected from the effects of the weather,
contamination and mechanical damage.
•
The module may not be used in an explosive environment.
•
To ensure adequate cooling the ventilation slots must not be covered.
•
The device must be disposed of in accordance with national statutory provisions.